Customers worldwide trust SKF SAF 23038 KA x 6.7/8 SAF and SAW pillow blocks with bearings on an adapter sleeve products for exceptional performance, lasting dependability and superior value. But when a repair or rebuild eventually is needed, insisting on genuine SKF bearing Housing Aftermarket Parts carries many valuable cost advantages. We established the “Keep it REAL” program to deliver all of them automatically when you specify “SKF SAF 23038 KA x 6.7/8 SAF and SAW pillow blocks with bearings on an adapter sleeve.” Locate a Distributor of A Systems Division On Horton Bearing Services you can easily configure the genuine SKF bearing Housing ... and that with just a few clicks! At the browse vane pumps section you can select a wide range of SKF bearing Housing to narrow down your selection to SKF SAF 23038 KA x 6.7/8 SAF and SAW pillow blocks with bearings on an adapter sleeve that is best suited for your application.
Customers worldwide trust SKF SAF 23038 KA x 6.7/8 SAF and SAW pillow blocks with bearings on an adapter sleeve products for exceptional performance, lasting dependability and superior value.
SKF SAF 23038 KA x 6.7/8 SAF and SAW pillow blocks with bearings on an adapter sleeveda | 174.625 | mm | |
Da | 289.999 | mm | |
Ca | 89.789 | mm | |
A1 | 158.75 | mm | |
A2 | 222.25 | mm | |
ba | 69.85 | mm | |
H | 336.55 | mm | |
H1 | 169.875 | mm | |
H2 | 66.675 | mm | |
J | min. | 441.325 | mm |
J | max. | 488.95 | mm |
J1 | 95.25 | mm | |
L | 558.8 | mm | |
N1 | 28.575 | mm | |
Threaded holes | |||
R1 | 104.775 | mm | |
R2 | 33.338 | mm | |
RG | 3/4 NPT | ||
PG | 1/4 NPT | ||
Oil level | |||
h | 47.625 | mm |
Housing | SAF 038 KA | |||
Bearing | 23038 CCK/W33 | |||
Adapter sleeve assembly | SNW 3038x6.7/8 | |||
Stabilizing ring | 2 x 38151-38 | |||
Labyrinth ring | 2 x LOR 154 | |||
|
End plug (suffix Y) | EPR 21 |
Bearing limiting speed | 2400 | r/min |
P60° | 226 | kN | |
P90° | 136 | kN | |
P120° | 85.9 | kN | |
P150° | 78.3 | kN | |
P180° | 94.3 | kN | |
Pa | 40 | kN |
Mass pillow block | 90.7 | kg |
Cap bolt | 4 x 3/4-10 UNC | |||
Cap bolt recommended tightening torque | 359.3 | N·m | ||
Cap bolt, SAE grade | 5 | |||
Eye bolt | 2 x 3/8-16 UNC | |||
Appropriate attachment bolt size | G | 1 | in | |
Initial grease fill | 793.8 | g |
Copyright © 2017 - 2019Horton Bearing Services All Rights Reserved